Conforms to safety requirements of FCC, RSS247, RSS210. Visit us at CAN ICES-3(B)/NMB-3(B) This product meets the applicable Innovation, Science and Economic Development Canada technical specifications. This product is manufactured by Amax Group 12645 Memorial Drive Suite F1 #388 Houston, TX 77024 Propel and Propel RC are the licensed trademarks of Rooftop Group LTD Singapore. Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Lappareil ne doit pas produire de brouillage Ģ. Lexploitation est autorise aux deux conditions suivantes :ġ. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. This device must accept any interference, including interference that may cause undesired operation of the device. Operation is subject to the following two conditions:ġ. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Cet quipement doit tre install et utilis avec une distance minimale de 20 cm entre le radiateur et votre corps. Cet quipement est conforme aux limites d'exposition aux radiations FCC/IC tablies pour un environnement non contrl. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This equipment complies with FCC/ IC radiation exposure limits set forth for an uncontrolled environment. (2) this device must accept any interference received, including interference that may cause undesired operation. (1) This device may not cause harmful interference, and Operation is subject to the following two conditions : This device complies with Part 15 of the FCC Rules. Consult the dealer or experienced radio/TV technician for help. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The battery is placed inside the drone, easily accessible, and uses an easy plug&play system.FCC Part 15 C Notice CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. In reality, it can span up to 10 minutes, but less if you are doing flips and some other stunts. The manufacturer claims up to 10 minutes of flight time, it is mostly in ideal conditions. The drone is powered by 3.7V, 1200mAh battery, and you get two of them in the standard package, which is a good thing. Read next: Promark Virtual Reality Drone P70-VR Review PROPEL CLOUD RIDER HD 2.0 BATTERY The controller requires 6 X AA batteries, so when loaded, it can be a little bit heavy. Besides that, you will find an auto take off and land button, a 360-degree flip button, and camera function buttons. There are two sticks, for vertical and horizontal control and throttle. Naturally, the drone with this much features can’t really have simple controls, but the manufacturers kept it as simple as possible. The 2, 4 GHz transmitter has good ergonomics, everything is where you would be expected it to be.
0 Comments
Leave a Reply. |